Ceramic Band Heater: The Maintainance Tips!
There is a wide variety of choices available to you when it comes to warming your house. One of the most typical types is a central heating system, which typically gets managed by a gas boiler. However, there are occasions when a more adaptable solution is required, either to supplement central heating or to serve as a substitute for it. The Ceramic Band Heater is one such solution, and they have several advantages that make them a very effective method of heating your house and maybe even your whole home.
A Ceramic Band Heater is a heating device that has the form of a ring and gets secured around a cylindrical component. The conductive mode of heat transmission gets used by band heaters to transmit heat. The majority of band heaters get designed to heat elements from the outside by clamping around the element's outer diameter and directing the heat within. Some device designs clamp around the pipe's internal diameter. Band heaters are often constructed with ceramic or mineral insulation to minimise the amount of heat lost to the surrounding environment.
How To Keep The Maintainance Of Ceramic Band Heaters
Keep The Heater Away From Moisture!
Moisture is one of the pollutants that get readily evident when present. If there is enough moisture in the air when the heater gets turned on, it will stop working as the electricity gets supplied.
The Ceramic Band Heater Suppliers In India suggest that if the heater is off for an extended time and exposed to an environment with a high humidity level. Sufficient moisture absorbed causes failure when the heater gets turned back on. The heater can fail if moisture gets wicked into the heater from the insulated lead wire but has become wet near the heater. When heaters stop working as soon as the power gets turned on, it is quite likely that moisture was the cause of the problem.
Do Not Over Heat Your Heater!
Choose the heater with the lowest wattage, however capable of maintaining the required operating temperature of the cylinder getting heated yet providing enough time to start up. It will be necessary for the controller to switch the heater on and off to maintain the proper temperature, which will result in a higher operating temperature during on-time if a heater with a greater wattage gets used. The lifespan of the heater will get reduced.
Ceramic Band Heaters At Shiva Heaters!
Comments
Post a Comment